12-11
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 12 Configuring Auto Smartports Macros
Configuring Static Smartports Macros
Configuring Static Smartports Macros
This section describes how to configure and enable static Smartports macros.
• Default Static Smartports Configuration, page 12-11
• Static Smartports Configuration Guidelines, page 12-12
• Applying Static Smartports Macros, page 12-12
Default Static Smartports Configuration
There are no static Smartports macros enabled on the switch.
fi Use as a conditional construct.
if Use as a conditional construct.
then Use as a conditional construct.
-z Use as a conditional construct.
$ Variables that begin with the $ character are
replaced with a parameter value.
# Use the # character to enter comment text.
Ta ble 12-3 Unsupported Cisco IOS Shell Reserved Keywords
Command Description
| Pipeline.
case Conditional construct.
esac Conditional construct.
for Looping construct.
function Shell function.
in Conditional construct.
select Conditional construct.
time Pipeline.
until Looping construct.
while Looping construct.
Table 12-2 Supported Cisco IOS Shell Keywords (continued)
Command Description