Filter
Top Products
25-2
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 25 Configuring CDP
Configuring CDP
Configuring CDP
These sections contain this configuration information:
• Default CDP Configuration, page 25-2
• Configuring the CDP Characteristics, page 25-2
• Disabling and Enabling CDP, page 25-3
• Disabling and Enabling CDP on an Interface, page 25-4
Default CDP Configuration
Table 25-1 shows the default CDP configuration.
Configuring the CDP Characteristics
You can configure the frequency of CDP updates, the amount of time to hold the information before
discarding it, and whether or not to send Version-2 advertisements.
Beginning in privileged EXEC mode, follow these steps to configure the CDP timer, holdtime, and
advertisement type.
Note Steps 2 through 4 are all optional and can be performed in any order.
Ta ble 25-1 Default CDP Configuration
Feature Default Setting
CDP global state Enabled
CDP interface state Enabled
CDP timer (packet update frequency) 60 seconds
CDP holdtime (before discarding) 180 seconds
CDP Version-2 advertisements Enabled
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
cdp timer seconds (Optional) Set the transmission frequency of CDP updates in seconds.
The range is 5 to 254; the default is 60 seconds.
Step 3
cdp holdtime seconds (Optional) Specify the amount of time a receiving device should hold the
information sent by your device before discarding it.
The range is 10 to 255 seconds; the default is 180 seconds.
Step 4
cdp advertise-v2 (Optional) Configure CDP to send Version-2 advertisements.
This is the default state.
Step 5
end Return to privileged EXEC mode.