1-16
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 1 Overview
Default Settings After Initial Switch Configuration
• The IGMP snooping querier feature is disabled. For more information, see Chapter 23, “Configuring
IGMP Snooping and MVR.”
• MVR is disabled. For more information, see Chapter 23, “Configuring IGMP Snooping and MVR.”
• Port-based traffic
–
Broadcast, multicast, and unicast storm control is disabled. For more information, see
Chapter 24, “Configuring Port-Based Traffic Control.”
–
No protected ports are defined. For more information, see Chapter 24, “Configuring Port-Based
Traffic Control.”
–
Unicast and multicast traffic flooding is not blocked. For more information, see Chapter 24,
“Configuring Port-Based Traffic Control.”
–
No secure ports are configured. For more information, see Chapter 24, “Configuring Port-Based
Traffic Control.”
• CDP is enabled. For more information, see Chapter 25, “Configuring CDP.”
• UDLD is disabled. For more information, see Chapter 27, “Configuring UDLD.”
• SPAN and RSPAN are disabled. For more information, see Chapter 28, “Configuring SPAN and
RSPAN.”
• RMON is disabled. For more information, see Chapter 29, “Configuring RMON.”
• Syslog messages are enabled and appear on the console. For more information, see Chapter 30,
“Configuring System Message Logging.”
• SNMP is enabled (Version 1). For more information, see Chapter 31, “Configuring SNMP.”
• No ACLs are configured. For more information, see Chapter 33, “Configuring Network Security
with ACLs.”
• QoS is disabled. For more information, see Chapter 34, “Configuring QoS.”
• No EtherChannels are configured. For more information, see Chapter 35, “Configuring
EtherChannels and Link-State Tracking.”
• IP unicast routing is disabled. For more information, see Chapter 36, “Configuring IP Unicast
Routing.”
• IPv6 unicast routing is disabled. For more information, see Chapter 37, “Configuring IPv6 Unicast
Routing.”
• No HSRP groups are configured. For more information, see Chapter 40, “Configuring HSRP.”
• IP multicast routing is disabled on all interfaces. For more information, see Chapter 44,
“Configuring IP Multicast Routing.”
• MSDP is disabled. For more information, see Chapter 45, “Configuring MSDP.”
• Fallback bridging is not configured. For more information, see Chapter 46, “Configuring Fallback
Bridging.”