Filter
Top Products
4
Operation
Operation l 4-3
Starting the Chiller
To start the chiller:
1 Toggle the power switch to the On or “I” position. The control display will
illuminate. Facing the chiller’s control, the “To Process” actual temperature
will be on the left, the setpoint temperature is on the right. See Operation
section entitled, Chiller Sequence of Operation.
2 Set the cooling temperature setpoint. Use the up arrow button ▲ on the
control, to raise the setpoint. Use the down arrow button ▼ to lower the set-
point. The temperature will ramp up at approximately 1 (one) degree per
second. After 2 (two) seconds of inactivity the setpoint entered will become
the targeted setpoint temperature.
On Position
NOTE: If the setpoint displays “OFF”
in the display, raise the setpoint
with the up arrow button
▲ to see
the actual setpoint.
✐
12 %
SD
Infinity Button
Pressing the “Infinity” button will acknowledge alarms
and return the user to the Main screen.