Filter
Top Products
Problem Possible solution
The hob burners will not light. Ensure the burner parts have been placed cor-
rectly.
Check that there is not a problem with your gas
supply. You can do this by making sure the other
gas appliances such as central heating or gas fires
are working.
The flame colour is orange/yellow. Due to the design of the burner the flame can ap-
pear to be orange /yellow (flame disturbance) in
certain areas of the burner this is a natural occur-
rence.
The burner is not igniting or only partially lighting. Check that the burner is dry and that food spillage
or cleaning fluids are not present on the burner.
This can be dried with a cloth and stubborn marks
cleaned away with a dry nylon brush (old tooth-
brush etc).
The burner sounds noisy. It is natural for the burners to emit noise as the gas
is being drawn through the burner and may re-
duce as they heat up.
The burner is emitting a popping sound. This is a natural occurrence when the burner is
alight and does not affect the performance of the
burner.
Noise. It is normal for some metal parts on the cooker to
produce noise when in use, this is due to expan-
sion and contraction when heating up and cooling
down.
Installation instructions
Important safety requirements
Warning! This appliance is not
suitable for installation in flats or
other mutli occupancy dwellings as
defined in clause 8.2.1 of IGE/G/5.
Where applicable Natural Gas and L.P Gas
versions of this appliance are available.
Check that this model is suitable for the type
of supply available.
This appliance must be installed and/or serv-
iced by a competent person, in accordance
with the Gas Safety (Installation and Use)
Regulations Current Editions and the IEE
Wiring Regulations.
For appliances installed in the Republic of
Ireland please refer to NSAI - Domestic Gas
Installation IS813 Current Editions and the
ETCI Rules for Electrical Installations.
In the Republic of Ireland a signed Declara-
tion of Conformity is issued by the installer
(IS813 Currents Editions Annex D.1).
Detailed recommendations are contained in
the following British Standard Codes of Prac-
tice – BS.6172, BS.5440: Part 2 and B.S.
6891. All British Standards must be ‘Current
Editions’.
Warning! This appliance must be
installed by a qualified electrician /
competent person (CORGI Registered).
Safety may be impaired if installation is
not carried out in accordance with these
instructions.
Before connecting the appliance make
sure that the voltage of your electricity
supply is the same as that indicated on
the rating plate. This is situated on the
lower front frame of the appliance and
can be seen upon opening the door.
Alternatively the rating plate may also be
found on the back or top of some mod-
els (where applicable).
Do not alter the electrical circuitry of this
appliance.
Provision for ventilation
This appliance is not connected to a com-
bustion products evacuation device. It shall
20 electrolux