Filter
Top Products
44 45
6.8 Out of range handling Bluetooth
If the Streamer is brought out of the Bluetooth range of the mobile phone,
the connection is momentarily lost. Normally, the devices will re-connect
when they are inside the Bluetooth range again.
If the Bluetooth connection is lost during a phone call, the phone will hang
up (this is standard Bluetooth headset behaviour).
If the Bluetooth connection is lost to an audio / music player while stream-
ing, the audio streaming stops and must be started again when the devices
are inside their Bluetooth range again.
6.9 Pairing to a Bluetooth device
Before using the Streamer with a Bluetooth mobile phone or a Bluetooth
enabled audio source, the Streamer must be paired to the device. This
means, a secure relationship is established between the two units,
enabling them to identify each other and communicate whenever they are
turned on and within range of each other.
You only have to make the pairing once as the units will hereafter recognize
each other.
Pairing is done by putting both units (i.e. the Streamer and the device) into
pairing mode. Here, the units automatically will search for and fi nd each
other. [The units must be kept only a few meters apart].
The following few basic steps will take you through a pairing sequence:
1. Prepare Device
Make sure that the Bluetooth function is turned on in the mobile
phone or the audio source.
Find the menu or identify the activation required to start the
pairing process.
Refer to the manual of the mobile phone or audio device to be paired for
detailed instruction on how to conduct the pairing. Normally, it is referred
to as “fi nd new audio equipment” and set up the device as instructed.
2. Set Streamer into pairing mode
Make sure that the Bluetooth function of the Streamer is turned off .
The Streamer is then put into paring mode by a very long press of 7
seconds on the Bluetooth button until it fl ashes. The Streamer is now in
pairing mode indicated by the fast blinking blue light.
See also section 6.6 for further info on Streamer Bluetooth pairing mode
3. Start Pairing
Activate the pairing feature on the device.
The device is now searching for active Bluetooth devices in the area.
When the Streamer is found by the device, the word ‘Streamer’ will ap-
pear in the display of the device (if featured).
Go to the word ‘Streamer’ and press select or OK.