Filter
Top Products
2. Build A Drink Models
Self adhesive drink selection and pricing decals are mounted onto a paper backing sheet
which is secured behind a transparent clip-in cover. To update drink pricing or replace
drink description decals, proceed as follows:
1. Open the front door of the machine. Release the catch securing the coin
mechanism cover and swing the cover to its open position.
2. Carefully remove the main controller board cover. Loosen the two screws above
the keyhole slots which secure the cover and lift the cover out of the machine.
3. Referring to the photograph, carefully press down the snap
fit clip (a) to release the transparent decal cover.
Remove the transparent cover and decal sheet from the
door moulding. Place the decal sheet face-up on a clean, flat
surface.
4. Updating pricing: Carefully remove the previous price decals from the drink
selection decals. Update the prices where necessary using new self adhesive decals
These are available as spares from the manufacturer.
5. Updating drink selections and pricing: When updating selection decals and
prices it will be necessary to use a new backing sheet. These are available as spares
from the manufacturer.
Peel the relevant drink selection decals from their backing
sheet (part no. PR10233000 & PR10918000) and apply to the
backing sheet using the printed guides as shown opposite.
Important: Ensure that drink selections used relate to drink
choices programmed into the machine software.
Apply price decals as described above.
6. Place the decal carrier behind the transparent decal cover and refit complete
assembly to the door. Ensure decal cover locating lugs are correctly located
before pushing the snap fit clip into place.
7. Replace the main controller board cover and tighten the screws to secure. Close
the coin mechanism cover ensuring that the catch is secured correctly. Close the
front door and ensure that the machine returns to standby mode.
Operators Manual
19
a