Filter
Top Products
March 2004 Manual 599082
- 17 -
Push Keylock to advance the Water Softener setting. Once the desired setting has been achieved push Power to
exit.
Selection of a setting affects how the Electronic Controller diverts supply water, how much water is treated, and how
much salt is used in regeneration, in a manner that optimises the performance of the Water Softener.
4.1.4 Auto Power Option (AP)
The automatic power up sequence that occurs when the tub is opened can be turned on or off using the Keylock
button. If the Scrubbing Brush is showing on the LCD then the auto power up sequence will occur when the tub is
Opened. If the Scrubbing Brush is not showing then the DishDrawer will not automatically power up when the tub is
Opened (the customer will need to push the power button each time they wish to use the DishDrawer). Push Power
to exit when the desired setting has been selected.
4.1.5 End of Cycle Beeps (EC)
The six beeps that occur at the end of every cycle can be turned on or off using the Keylock button. If the
Scrubbing Brush is showing on the LCD then the end of cycle beeps are activated. If the Scrubbing Brush is not
showing then the end of cycle beeps are deactivated. Push Power to exit when the desired setting has been
selected.
4.1.6 Closed Drawer Option (Ld)
The Closed Drawer Option can be turned on or off using the Keylock button. If the Scrubbing Brush is showing on
the LCD then the Closed Drawer Option is selected and it will keep the DishDrawer locked at all times by bringing
the lid down. When this mode is selected the customer needs to push the power button to lift the lid whenever they
want to open the drawer. When they close the drawer again the lid comes down automatically after 30 seconds and
locks the tub. If the Scrubbing Brush is not showing then the Closed Drawer Option is deactivated.
4.1.7 Clean/dirty Dish Symbol (dS)
(not available on integrated models)
The Clean/dirty dish symbol can be turned on or off using the keylock button. If the Scrubbing Brush is showing on
the LCD then the Clean/dirty dish option is selected. This means that the end of cycle clean dishes symbol will
remain in the LCD display until the power button is pressed to clear it. If the Scrubbing Brush is not showing then the
Clean/dirty dish symbol will disappear when the drawer is first opened at the end of a cycle (factory setting).
4.1.8 Dry Enhancement Option (LH)
(available in prefinished products from MEM741743, manufactured after 21/5/03,
software vesion 3.2.06
available in integrated models from MKM704522, software version 3.2.07)
Dry Enhancement Option can be turned on or off using the keylock button. If the Scrubbing Brush is showing on the
LCD then the Dry Enhancement Option is selected.
This means the lid will stay down and the drying fan will continue running for 4 hrs after the wash program
completes.
If the customer wishes to open or stop the DishDrawer during this 4 hr period, they can do so by pushing the
POWER or START / PAUSE button. This will reset the feature until the end of the next wash program