Filter
Top Products
March 2004 Manual 599082
- 38 -
9.5 Detergent Dispenser
9.5.1 Remove the drawer front as per instructions in 9.1.
9.5.2 Disconnect the two wiring loom connections off the
dispenser coils.
Note: Push back locking tabs to allow connectors to
release.
9.5.3 With a small bladed screwdriver carefully release the small
plastic clips holding the rinse aid indication LED in place
and remove the LED.
9.5.4 Unclip the fill hose on the dispenser
9.5.5 While holding the dispenser unscrew the six T10 Torx
drive screws securing the brackets around the dispenser.
9.5.6 The dispenser can now be removed from inside the tub.
9.5.7 To open up the dispenser door fully, first open the door using the release catch then squeeze the top sides
of the door. This will release the door to the fully open position. This can be done with the dispenser in place.
9.5.8 Refit in reverse manner ensuring the dispenser gasket is located correctly.
9.6 Electronic Controller
9.6.1 Remove the drawer front as per instructions in 9.1.
9.6.2 Disconnect all the wiring connectors on the controller
apart from the LCD/Badge plug
9.6.3 Now release the clip on the right-hand side of the
controller just below the light pipes by firmly pushing it in
towards the controller.
9.6.4 The bottom of the controller can now be lifted out to an
angle of about 45° at which point the top of the controller
will come free.
9.6.5 Disconnect the LCD/Badge plug.
9.6.6 Refit in reverse manner.