Filter
Top Products
March 2004 Manual 599082
- 41 -
9.12 Locking Ring, Element Plate and Motor Assembly Removal
9.12.1 Remove the drawer front, filter plate and rotor assembly
as per instructions in 9.1 and 9.7 and 9.8.
9.12.2 Remove the wiring cover and disconnect and remove
the tub as per instructions in 9.9 and 9.10 and 9.2.
9.12.3 Unplug the motor wiring harness from the electronic
controller.
9.12.4 While lifting the tab on the locking ring as shown, rotate
the ring anti-clockwise until it comes free of tub tabs.
9.12.5 Take care not to damage any motor wiring as the locking
ring is turned (refer picture).
9.12.6 This also releases the motor housing from the locking
ring.
9.12.7 Holding the pump housing on the motor assembly lift the
locking ring, heating plate and motor clear of the tub.
9.12.8 The suction pipe of the drain molding will slide out of the
tub drain area.
9.12.9 You may now lift the locking ring clear of the motor
assembly. This will allow the heater plate and motor
assembly to come apart
9.12.10 Be careful of the two large ‘O’ rings which seal
between the motor assembly and heater plate and the
heater plate and tub, these and the tub sealing area
must be clean and put in the correct place before
reassembly takes place.
9.12.11 Check both the drain cuff ‘O’ ring and suction pipe ‘O’
ring for deformation and damage. Lubricate and if
necessary replace ‘O’ rings before reassembly.
9.12.12 Reassemble in reverse manner ensuring all locking
ring tabs are engaged.