Filter
Top Products
March 2004 Manual 599082
- 40 -
9.10 Tub Disconnection
9.10.1 Remove the drawer front as per instructions in 9.1.
9.10.2 Remove the wiring cover as per instructions in 9.9.
9.10.3 Disconnect the fill hose from the dispenser (water may drip).
9.10.4 Disconnect the chassis harness plug from the electronic
controller.
9.10.5 Disconnect the element harness plug and earth wire from the
element plate.
9.10.6 Unclip the drain hose cuff from the motor assembly taking care not
to misplace the non-return flap valve.
9.10.7 Unclip the drain hose, fill hose and the wiring loom from the under
side of the tub.
9.10.8 Now remove the tub as per instructions in 9.2.
9.10.9 Refit in reverse manner.
Note: When replacing a fill hose, transfer the Link Support clip markings
from the old to the new hose.
9.11 Rotor Sensor Removal
9.11.1 Remove the wiring cover as per instructions in 9.9.
9.11.2 Unplug the wiring connection from the rotor sensor.
9.11.3 Release the tab locking the rotor sensor in place as shown and lift
the rotor sensor out.
9.11.4 Refit in reverse manner.