Fisher & Paykel E442BRXFDU Refrigerator User Manual


 
12
Installation instructions (all models)
Moving or storing your refrigerator
If your refrigerator is turned off for any reason, wait 10 minutes before turning it back on. This
will allow the refrigeration system pressures to equalise before restarting.
Moving your refrigerator
On Ice & Water model refrigerators disconnect the water supply.
Turn off the appliance and unplug from the power point. Remove all food.
Turn the adjustable feet to the right as far as they will turn (refer to page 9).
Ease the refrigerator out of its position. Tuck the power cord away and tape the doors closed.
Tape the shelves in place. If the cabinet needs to be placed at an angle or laid down, carefully
lay it on its side (the right hand side when viewed from the front).
Relocate and install. If the appliance has been left on its side for any length of time, leave it
standing upright for at least 10 minutes before turning on.
Storing your refrigerator
When storing your cleaned appliance, leave the doors open. This allows air to circulate and
prevents the build-up of bacteria and moulds.
Before using again, clean well using a mixture of warm water and liquid dishwashing detergent
or baking soda (add 1 teaspoon of baking soda to every 500 ml of water). Rinse with clean water.
Holiday time
We recommend you leave your refrigerator operating while you are on holiday.
Door conversion (Non Ice & Water models only)
If you need to hinge your door on the opposite side we recommend that you call your local
Fisher & Paykel Authorised Service Centre or Dealer to make this conversion. Active Smart™
refrigerators with silver handles need to be ordered either with left or right opening doors
and can not be interchanged. All other models need to have an appropriate conversion kit for
your model refrigerator. The kit is available from your Authorised Service Centre or Dealer. Full
instructions are included in the conversion kit.