Fisher & Paykel E442BRXFDU Refrigerator User Manual


 
28
Exterior
Stainless exterior doors (Iridium or EZKleen finishes)
It is important when cleaning the exterior door surface of your refrigerator, to only use liquid
dishwashing detergent dissolved in warm water and a soft cloth.
Dry the door with a clean, lint free cloth.
The use of any abrasive or stainless steel cleaners and solvents will damage the door surface.
Other exterior surfaces
Clean all other exterior surfaces with a mix of warm water and detergent and a soft cloth.
If necessary, clean the magnetic door gasket and the centre door gaskets with an old
toothbrush, warm water and liquid dishwashing detergent.
Water evaporator tray
The water evaporator tray is found above the compressor at the
back of the refrigerator. The tray may require infrequent cleaning.
Carefully move the refrigerator out from the wall.
Switch off the appliance.
We do not recommend that you remove the evaporator tray. If
cleaning is required, excess water can be soaked up from the
evaporator tray using a sponge. Wipe out with warm water and
detergent or disinfectant.
Reassemble taking care not to over-tighten the fasteners.
Switch on the appliance.
Water dispenser pad and interface (Ice & Water models)
We have incorporated a Dispenser and Key Lock function in your refrigerator to make cleaning
easier (refer to page 19). This will help you to avoid accidental water dispensing while you clean.
Clean the pad and interface panel with a soft damp cloth.
Drip tray (Ice & Water models)
To clean, take the tray out of the dispenser panel
and pull the two halves of the tray apart.
Clean in warm water with a mild detergent.
Dry the tray and clip back together.
Re-insert the tray back into the dispenser panel.
Cleaning and caring for your refrigerator (all models)
Fig.19 Drip tray removal