Filter
Top Products
21
Using your water dispenser (Ice & Water models only)
Dispensing pad
Your water dispenser has been designed for one handed operation. Simply push your glass up
against the dispenser pad located at the back of the dispenser area. This pad requires only a
gentle press to activate.
Please remember that pressing very hard against the dispensing pad will not make the
dispenser operate faster or produce greater quantities of water.
First use
After installation, on the first use, allow approximately a one minute delay while the dispensing
pad is pushed until water is dispensed. This will allow the tank to fill completely.
After you fill the tank for the first time, dispense and discard approximately 8 – 10 L stopping
intermittently to flush the tank out.
Dispensing
To dispense water push the dispensing pad gently, using
a glass or container.
When you dispense water, a light will appear above the
dispensing area, and on the display screen. The water fill
icon
will also appear.
To stop the flow of water, simply pull your glass away
from the dispensing pad.
Important!
To avoid damage to property or personal injury do not
put hands, fingers or objects up the dispenser opening.
Please note that once installation is complete a few drips may appear out of the dispenser over
the next few days as the remaining trapped air is cleared.
Fig.12 Water dispenser