Filter
Top Products
16
Using the meat probe
Use your meat probe to accurately judge when your meat is perfectly cooked. You can use the
probe on TRUE AERO, AERO BAKE, ROAST, AERO GRILL and BAKE functions.
1
Select the oven function and temperature. Preheat the oven if
appropriate. Remember ROAST and AERO GRILL do not require
preheating.
2
Insert the metal probe horizontally into the centre of the
thickest part of the fully defrosted meat. The thicker the
meat, the longer it will take to cook, so it is important that
the probe is measuring the temperature of the meat at its
thickest point. Make sure the probe does not touch bone (pull
probe away from bone 1.5 cm), fat or gristle, as these will heat
up more quickly than the lean meat.
3
Place the meat on the grill/roast system.
4
When the oven has preheated (if required) to the set
temperature, place the grill/roast system in the oven and
insert the plug end of the meat probe into the probe socket,
using an oven mitt if the oven is hot. The probe socket is on
the left hand side of the oven, just under shelf position 7.
Make sure the probe is pushed completely into the socket,
then close the oven door.
5
Select the upper or lower oven for double models using the
cavity selector button.
6
Press the PROBE button on the control panel. The preset temperature of 65°C and PROBE will
light up in the display. If you want to select a different internal food temperature from the preset
temperature, rotate the
PUSH TO
CLEAR
button while the PROBE symbol is flashing. For temperature
guidelines, see the ‘Cooking guidelines’ section.
7
During cooking, the display will show the actual internal temperature of the meat. To look at the
set internal temperature, press
PROBE.
8
The oven will beep and automatically turn off when the meat reaches the set internal
temperature. The temperature and function displays will remain on and the oven light will go
out.
9
Return the oven to manual operation by pressing the
PUSH TO
CLEAR
button. Turn the function and
temperature knobs to OFF.
To cancel the probe setting before the set temperature has been reached, press the
PROBE button
and then the
PUSH TO
CLEAR
button.
a
Metal probe
b
Plug
c
Handle
d
Cable
a
c
c
d
b
Using your oven