Filter
Top Products
14
Installation instructions
Connecting the power supply cable
Important!
This cooker must be connected to the electricity supply only by an authorised person.
Your cooker is supplied with a certified 4 prong NEMA 14-50P power cord and should be
plugged directly into a properly grounded socket. Do not under any circumstances cut or
remove the forth (ground) prong from the power plug. Do not ground to a gas pipe.
Do not have a fuse in the neutral or ground circuit.
Do not use an extension cord.
Check with a qualified electrical installer if you are not sure if the range is properly grounded.
If codes permit, and a separate ground wire is used, it is recommended that a qualified electrical
technician determines the ground path and wire gauge are in accordance with local codes.
Be sure that the electrical connection and wire size are adequate and in conformance with:
ANSI/NFPA 70 latest addition and local codes and ordinances;
CSA standard C22.1, Canadian Electrical Code, Part 1 - latest edition and local codes and
ordinances.
When a 4-wire, two phase 240-208/120V 60Hz AC only electrical supply is available a 50 amp
maximum circuit protection is required, fused on both sides of the line.
Replacing the power cord
Replacements should only be made by qualified electrical technicians.
If replacing the power cord, use only a suitable UL or CSA approved one. Tighten the power cord
using the power cord strain relief bracket supplied with the appliance. Allow enough slack to
easily attach the cord terminals to the terminal block.
Voltage and Power Consumption
240-208 / 120V 60Hz 10350W (240V) 7800W (208V)
43.51A (240V) 37.82A (208V)
Power supply cord with
NEMA 14-50P plug
Standard NEMA 14-50R wall receptacle
Location of Nameplate
US
CA