Filter
Top Products
40
3
Select the Self Clean Function
The display will show
The
P will flash.
4
Adjust the cycle time (optional)
You may set the time between 1-1/2 hours (P1:30 and 3 hours (P3:00). For heavy soiling use
a longer time.
Press the
button - the P will go out.
Use the
and buttons or rotate the temperature dial to change the time.
After a few seconds the
P will start to flash again. Alternatively, press the button
to confirm and the
P will flash.
5
Start the cycle
Press the
button. The P will stop flashing.
The oven will come on and the
indicator will show in the display.
After a few seconds the door will lock and the door lock indicator light will come on.
The display will start to count down.
Note: If the door is not shut completely, after a few minutes the oven will switch off, the display
will show ‘door’ and the oven will beep. See ‘Troubleshooting’.
6
At the end of the Self Clean cycle
The oven will turn off.
The display will show
P:00 and a flashing A
7
Turn the function dial to OFF.
The door will remain locked.
The door lock indicator will remain on.
The display will show ‘hot’.
When the oven has cooled to a safe temperature, the door lock indicator will go out and the
door will unlock. The display will show the time of day. This may take 30 minutes.
Note: The oven will still be very warm. To avoid burns, wait for the oven to cool completely
before wiping out the ash and replacing side racks and shelves.
To cancel a Self Clean cycle
Turn the function dial to OFF.
Note: The oven door will remain locked until the oven has cooled to a safe temperature. The door
lock indicator light will remain on, and the display will show ‘hot’.
We do not recommend that you start a new Self clean cycle before the oven has cooled
completely.
P
1:30
A
US
CA
Care and cleaning