Filter
Top Products
16
16
33
FAN
GAS OVEN
KNOB
SETTING
GAS
OVEN
°F °C °F °C
200 93 1 200 93
240 116 2 245 118
285 141 3 270 132
330 166 4 345 174
375 191 5 380 193
420 215 6 455 235
475 246 7 505 263
530 277 8 555 291
OK OK
DO NOT TURN
Fig. 3.1
OVEN THERMOSTAT
The numbers printed on the control knob (fig. 3.1) indicate the increasing oven tem-
perature value (see temperature table, in °F near the control knob or temperature table,
°F/°C, below the Fig. 3.1).
Left column of the temperature table refers to oven burner used in combination with
the fan motor while right column refers to oven burner used in the normal convection
mode (without fan motor).
To regulate the temperature, set the chosen number to the mark on the bezel.
The position
BROIL serves only to turn on the broil burner.
Fig. 3.2
OVEN BURNER
It carries out normal “oven cooking”.
The gas flow to the burner is regulated by a thermostat which allow to maintain the
oven temperature constant.
The control of the temperature is assured by a thermostatic probe positioned inside
the oven.
The probe must be always kept in its housing, in a clean condition, as an incorrect posi-
tion or encrustment may cause an alteration in the control of the temperature.
OVEN LIGHT AND FAN MOTOR
The oven light and the fan motor are controlled by a switch knob on the control panel
(fig. 3.2). To light up the oven lamp turn the knob clockwise to
LIGHT position.
To operate the fan motor turn the knob clockwise to
LIGHT & FAN position.
In this setting also the oven lamp is lighted.
WARNING: The switch knob can be turned only clockwise from
OFF to LIGHT & FAN
position and counter-clockwise from OFF to LIGHT position.
DO NOT TURN from
LIGHT & FAN to LIGHT position or from LIGHT to LIGHT & FAN
positions. DO NOT FORCE.
IMPORTANT NOTE: The fan motor can be used in combination only with the oven
burner. A safety device switches off the fan motor when the gas oven/broil control knob
is turned on
BROIL position.
OFF
OFF