Filter
Top Products
23
23
5
CORRECT POSITION OF THE
SEMI-RAPID BURNERS
It is very important to check that the burner
fl ame spreader “B” and the cap “A” have
been correctly positioned (see fi gs. 5.1 and
5.2 ). Failure to do so can cause serious
problems.
CORRECT POSITION OF THE
DUAL BURNERS
The Dual burner must be correctly positio-
ned (see fi g. 5.3); the fl ame spreader “E”
must be fi tted as shown by the arrows (fi g.
5.4). Then position the cap “C” and the ring
“D” (fi gs. 5.3 and 5.6). Correctly positioned
burner should not rotate (fi g. 5.5).
IMPORTANT: NEVER unscrew the bur-
ner inner fl ame speader fi xing screws
(fi g. 5.7). The inner fl ame spreader can
be removed ONLY by an authorised ser-
vice agent. Damage to the appliance will
occur if not observing this condition and
this may result in serious injury to the
user. The manufacturer declines every
responsibility for any inconvenience re-
sulting from the non-observance of this
condition.
CLEANING THE DUAL BURNER
Pay special attention to this burner: the two
holes “H” on the inner fl ame spreader (fi g.
5.8) must always be kept clean.
When cleaning, remove the external fl a-
me spreader “E” (fi g. 5.3) and use a cotton
bud, toothbrush, or some other item to cle-
an out any incrustations or dirt from the two
holes marked “H” (Fig. 5.8). This procedure
is necessary to ensure the burner functions
correctly.
If the burner does not function correctly
and it is not possible to clean out any
incrustations or dirt from the two holes,
contact the After-Sales Service.
Fig. 5.6
Fig. 5.4
Fig. 5.3
Fig. 5.2
Fig. 5.1
T
S
B
A
Fig. 5.5
T
S
D
C
Fig. 5.7
Fig. 5.8
H
Inner
fl ame spreader
Fixing screws
E