Fisher & Paykel OR90SDBGFX Oven User Manual


 
31
Care and cleaning
S
F
C
T
Cap
Ignitor
Flame
spreader
Fig. 35 Replacing the semi-rapid burner caps
Fig. 34 Correct line-up of semi-rapid burner parts
Probe
Burner parts and trivets
You can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean
spills regularly before they become burnt on. Do not wash these parts in a dishwasher.
After cleaning, check that the burners and their flame spreaders are dry before replacing
correctly.
It is very important to check that the burner flame spreader and the cap have been correctly
positioned. Failure to do so can cause serious problems.
Note: to avoid damage to the electronic ignition, do not try to light a burner without all burner
parts in place.
Replacing the semi-rapid burners
Carefully replace the burner parts as per the following Figs.
Check that:
the ignitor is always clean to ensure trouble-free sparking.
The probe is always clean to ensure correct operation of the safety valves (some models only)
Note: both the ignitor and probe must be very carefully cleaned using a toothbrush and
methylated spirits (see Fig.29).