Filter
Top Products
1-22
The suction tube heater and flexible hose heater are wired directly into the 24VAC source. They
remain energized as long as the unit is plugged in.
M
Pump Relay Coil
Micro-switches
Pump Motor Switch
Pump Motor
24 VAC
Line VAC
Filter Magic Simplified Wiring Diagram
Return Line Heater Tapes
Suction Tube (Pan) Heater Tape
1.9.6 Leakage Problems
Leakage of the frypot almost always will be due to improperly sealed high limit switches, thermo-
stats/temperature probes, and drain fittings. When installed or replaced, each of these components
must be sealed with Loctite PST56765 sealant or equivalent to prevent leakage. In very rare cases, a
leak may develop along one of the welded edges of the frypot. When this occurs, the frypot must be
replaced.
If the sides and/or ends of the frypot are coated with oil/shortening, the most likely cause is spillage
over the top of the frypot rather than leakage.
The clamps, which hold the drain tube sections together, may loosen over time as the tubes expand
and contract with heating and cooling during use. If the section of drain tube connected to the drain
valve is removed for whatever reason, make sure that its grommet is in good condition and properly
fitted around the nipple of the drain when it is reinstalled. Also, check to insure that the drain tube
runs downward from the drain along its whole length and has no low points where oil or shortening
may accumulate.
1.9.7 Basket Lift Malfunctions
45 Series fryers may optionally be equipped with automatic basket lifts to ensure uniform cooking
times. The lifts may be configured for manual control or for control via a Basket Lift Timer or
Computer Magic computer. Basket lifts will always come in pairs, although each operates inde-
pendently.
In units configured for manual (push-button) controls, a mechanical or electrical timer controls volt-
age to the system. A rotary knob is turned to set the cook time, and pressing the button in the middle
of the knob activates the motor.
In units with Computer Magic or Basket Lift Timers, timing circuitry in the controller initiates and
stops basket lift operation depending upon the variables programmed by the operator. When the