Filter
Top Products
INSTALLATION INSTRUCTIONS
(ccmtinued)
t
v
PREPARE THE OPENING (cent’d)
Flooring Under the Range
Your range, like many other household
items, is heavy and can
settle
into soft
floor coverings
such
as cushioned vinyl or
carpeting.
When
moving
the range on this type
of flooring, use care, and follow these simple and
inexpensive instructions.
The range should be installed on a 1/4 inch thick
sheet
of
plywood (or similar material) as follows:
When the floor covering ends
at
the front of the
range,
the area that the range will rest on should
be built
up
with plywood to the same level or
higher than the floor covering. This
will
allow
the range to
be
moved for cleaning or servicing.
STEP 2
PREPARE FOR ELECTRICAL CONNECTION
Use only a 3-conductor, or if required a
4-
conductor range cord set as noted below. These
cord sets
are
provided with ring type terminals.
The electrical rating
of
the
cord must be 125/250
volts
minimum,
40
amperes.
NOTE:
Only a 4-conductor cord is to be used
when
the appliance is installed in
a
mobile home
or where
local
codes do not permit grounding
through the neutral.
STEP 3
1.
Locate connector block at the bottom rear of
range and remove rear wiring cover.
2. Directly below the connector block is a hole
with a knockout ring for accommodating
condui
fit~ings.
Brackets provided are used to support
the flexible cord strain relief, which must
be
securely attached
to
the cord set.
WIQING
COVER
A
JNECTOR
CK
STRAIN
RELIEF
BRACKETS
(PHOVIDED
WITH RANGE CORD
sET
NfJT PART
(_JF
RANGE
)
STEP
4
3-WIRE SYSTEM
Power
Cord Installation-Insert screws
through power cord terminals so that the
screws
pass through connector
block
terminals and
engage nuts. Tighten screws
securely”.
SCREW+
$3
+
POWER CORD
>%
&/
RING TERMINAL
*
&
+
POWER
CORD
CONNECTOR
BLOCK
TERMINAL
@
&
--
~::ABLE
Cable Direct
h@.allatiow--Ckimp
bare
wires
between the connector block terminals
anci
movable nuts with screws tightened securely,
1. Copper Wiring
~
SCREW
CONNECTOF?
TERM IN Al-
Connect the neutral or grounded wire of
tht~
supply circuit to the neutral terminal
of
the
connector block. located in the center.
The
power leads must be connected to
the
outside
(brass colored) terminals.
NEUTRAL
TERMINAL
NG
STRAP
ING TO
RAN
GE)
WLA
w..TI~~:
~()~~~~oR
BLCJCK
1$$
APPROVED
I?OR
COPPER WIRE
CONNECTION
ONLY.
34