Filter
Top Products
~“
.&
To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
c1
1.
Press the
CLOCK
CLOCK pad.
Bake or CLEAN cycle.
2. Press the INCREASE
or DECREASE pad
to set the time of day.
Timer
To Set the Timer
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
c1
1.
Press the The timer will start automatically
TIMER
TIMER pad. within a few seconds of releasing
the pad.
on
the timer is
9
hours and 55
2. Press the INCREASE or
The timer, as you are setting it,
minutes.
DECREASE pad to set the
will display seconds until 1 minute
amount of time on timer.
is reached.
Then it will display minutes
and seconds until 10 minutes
is reached.
After 10 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
To Reset the Timer
To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or
Press and hold the TIMER pad until the word
DECREASE pad until the desired time is reached.
“TIMER” disappears from the display.
If “TIMER” is not displayed,
press the TIMER
pad first, then follow the instructions above to set
the timer.
End of Cycle Tone Display Messages
The end of cycle tone is a series of
3
beeps followed
If “door” appears on the display,
the door latch
by
I
beep
every
6
seconds.
If
you would like to
handle is not moved all the way to the right. Move
remove the
signal
that beeps every 6 seconds. press
the latch handle and cleaning will start. If “LOCK”
tind
hold the CL. EAR/OFF
pad
for 10 seconds. appears in the display, the oven door is in the locked
To return the signal that beeps every 6 seconds, press
position. BAKE, BROIL and COOK TIME cannot be
and hold the CLEAR/OFF pad
for
10 seconds.
set if’ the door is in the locked position.
Power Outage
Atlcr a power outage, when power is restored. the display will flash and
,:
shown will no
Iongcr
be correct-f-or example, after
a
5-minute power
inl~l”l”llption
the clock will
bc
5 minutes
S
1
OW
. All other functions that were
in operation when the power went out will have to be programmed again.
7