Filter
Top Products
The Problem Solver
Stainless Steel Range
Questions ?
Use this
problem
solve*!
PROBLEM POSSIBLE CAUSE
SURFACE BURNERS
DO NOT LIGHT
•Burners assembled incorrectly after cleaning. Make sure the burner
assembly is put together correctly and that the port ring is aligned.
•Clean the ignitor orifice.
•Inspect the manual cu(-offvalve to insure daat it is not closed.
•Make sure the electrical plug is plugged into a live power outlet.
•Check for a power outage.
•Improper LP gas connection. See the Installation lnsu'uctions.
SURFACE BURNER
FLAMES VERY
LARGE OR YELLOW
TICKING SOUND OF • The spark ignitor is not deactivated. Turn the burner OFF and
SPARK IGNITOR relight. Some ticking is normal. If ticking is excessive call for smwice.
AFTER SURFACE
BURNER LIGHTS
STRONG ODOR
OVEN LIGHT
DOES NOT WORK
FOOD DOES NOT
BAKE OR ROAST
PROPERLY
FOOD DOES NOT
BROIL PROPERLY
•Improper air/gas ratio in surface burners. Adjust the air shutters.
•The light bulb is loose or defective. Tighten or replace the bulb.
•The switch operating light is broken. Call for service.
•The oven con(rols are improperly set. See the "How to set your oven
for baking or roasting" section.
• Incorrect cookware or cookware of improper size being used.
See the "How to set your oven for baking or roasting" section.
•Use a foil tent to slow down browning during roasting.
•The oven control is not set at BROII. Push in the BROIL selector
button for Ihe oven you want to use.
•The oven door is not open to the broil stop position as recommended.
•Improper shelf posilion being used. See the Broiling Guide.
•Food is being cooked in a hot pan.
•Cookware is not suited for broiling. Use the broiling pan and grid
that came with your range.
•Aluminum foil used on Ihe broiling pan and grid has not been fitted
properly and slit as recommended.
•In some areas Ihe power (voltage) may- be low. Preheat 1he broil
element for 10 minutes. Broil for the longest period of time
recommended in the Broiling Guide.
31