Filter
Top Products
(;are and (;leaning
Wall Ov_,_
([OOY_
FelYtOT} (IJ
The door is very heavy. Be cm'eful when removing
and lifting the door.
Do not I!fi tke door b3' tke kandh,.
To remove the door:
1 Fully open the door.
2 Pull the hinge locks down towaId the door
fl'ame, to the unlocked position. A tool, such
as a small fiat-blade screwdvh'er, may be
required.
3 Firmly grasp both sides of the door at the lop.
4 Close door to the door reI/lo\ al position,
which is most of the way and lift it up and om
tmtil the hinge a*m is clear of the slot.
To replace the door:
1 Firmly grasp both sides of the door at the top.
2 With the door at the same angle as the
remo\al position, seat the indentation of the
hinge arm into the bottom edge of the hinge
slot. The notch in the hinge arm must be
fully seated into the bottom of the slot.
3 Fully open the door. If the doo_ will not hilly
open, the indentation is not seated correctly in
the bottom edge of the slot.
4 Push the hinge locks up against the front
fl'ame of the oven cavity, to the locked
position.
5 (;lose the oven door.
Slot
d_b
Hinge lock
Pull hinge locks down to unlock
Bottom earm
edgeof
Indentation
Hinge..._/!
lock //I
Push hinge locks up to lock
_PYobg
The temperature probe may be cleaned with
soap and water or a soap-filled scouring pad.
Cool the teml)eramre probe beflwe cleaning.
Scour stubborn spots with a soap-filled scom'ing
pad, rinse and dry.
Do not imme*se the tempemtu*v probe in ware*:
Do not sto*v the temp(,rature probe in the oven.
38