Filter
Top Products
27
After a
clean cycle
You may notice some white ash in the oven. Wipe it up
with a damp cloth after the oven cools.
If white spots remain, remove them with warm sudsy
water and rinse thoroughly with a vinegar and water
mixture. These deposits are usually a salt residue that
cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle, repeat
the cycle.
You cannot set the oven for cooking until the oven is
cool enough for the door to unlock.
How to
delay the
start of
cleaning
You can set the oven to delay the start of cleaning, clean
for a selected length of time and turn off automatically.
NOTE: Before beginning, make sure the clock shows
the correct time of day.
Turn the Oven Mode knob to CLEAN.
Turn the Oven Temperature knob to CLEAN.
The oven will be set to clean for its normal clean
time of 5 hours. (If a clean time less than 5 hours
is needed, turn the Mini-Knob to the clean time
desired.) Push to enter it.
You can change the clean time to any time between
3 and 5 hours, in 15 minute increments, depending
on the amount of soil in your oven.
NOTE: The Mini-Knob must be pushed for the
self-clean cycle to be set.
Push the DELAY START button. The current time
of day will flash in the display.
On double oven models, push the DELAY START
button once to set the upper oven and twice to set
the lower oven.
Turn the Mini-Knob to select and push it to enter
the time of day you want the oven to turn on and
start cleaning.
NOTE: The Mini-Knob must be pushed for the
self-clean cycle to be set to start at the time of day
entered.
The oven is now set to turn on at the time of day you set
and clean for the set amount of clean time.
If your oven is connected to a 208V electrical supply, we
recommend that you set your clean time for 5 hours.
If LOCKED flashes in the display, the self-clean cycle has
been selected but the door is not closed. Close the oven
door.
To check the start time, push the DELAY START button.
To change it, turn and push the Mini-Knob.
The display will show START TIME. When the start time
is reached, the oven will turn on automatically.
The display will show CLEAN and the clean time
remaining.
As the oven heats to the clean temperature, the door
will lock automatically. The LOCKED light will turn on.
The display will show the clean time remaining.
It will not be possible to open the oven door until the
temperature drops below the lock temperature and the
LOCKED light goes off.
After the clean cycle is complete and the oven
has cooled, END will show in the display and
the LOCKED light will turn off. Turn the Mode
Selector and the Temperature knobs to OFF.
To stop a clean cycle, turn the Mode Selector and
the Temperature knobs to OFF. When the LOCKED
light goes off, indicating the oven has cooled below the
locking temperature, you will be able to open the door.
NOTE: On double oven models, you can set a delay clean
in both ovens at the same time. Turn the Oven Mode knob
and the Temperature knob of the second oven to CLEAN.
The second oven set will automatically delay the start of
cleaning until the end of the first oven’s clean cycle.
Self-Cleaning Oven
Wall Oven
Temperature knob
Mini-Knob
Turn to select
Push to enter
Push to
select
Double oven display shown.
Oven Mode knob