Filter
Top Products
36
5. Turn the oven thermostat control knob clockwise until
it can no longer be turned (see
c). Bake indicator
will come on.
6. Your oven is now in the self clean mode and will operate
in self clean mode for the time you have set.
7. At the end of the cycle the oven will shut off and the
clock will
"P0.00" and the symbol "AUTO"
alternately.
8. Turn the thermostat control knob to “0”. The clock will
until the oven is unlocked. The thermostat must
9. The safety interlock is active until the oven has cooled
to a safe temperature (approximately 1 hour) You will
not be able to unlock the oven door during this cool down period. Please do not attempt to open door
while locked, or damage to locking mechanism may occur.
Caution: Even after the oven door lock has released the oven may still be too hot to touch.
Use caution to avoid burns.
10. When the oven has
cooled, wipe away the remaining grey ash with a damp cloth.
DANGER:If a large amount of smoke comes out of the oven vent it is probably because you have left
something in the oven or the storage drawer. Turn off the oven thermostat control. Allow the oven
to cool and use caution when removing any utensils or debris, to avoid burns.
Note: Self clean mode may be cancelled at any time... by turning the oven thermostat control back
to "0". Unlatch the self clean door latch.
Remember, the safety interlock is active until the oven has cooled to a safe temperature - do
not attempt to force open.
Time Delay Self Clean
To set TIME DELAY self clean
1. Lock the oven door by pushing the self clean door latch fully to the right. (see
B)
2. The clock will display "P1.30" which indicates one hour thirty minutes of self clean time. As well "
" and "AUTO" symbol will light up, indicating the self clean cycle is active.
3. Press bake "
" button on the clock
4. Tap the
button for additional self clean time in one minute increments. Press and hold to advance
quickly to 3:00 hour maximum. 3 hours is recommended for maximum cleaning.
Self Clean
position
Figure C
be in the O position prior to moving lock to the
unlocked position.