Filter
Top Products
8
Installation and Operations Manual
Programming XR-40CX or XR-60CX
Dixell Electronic Controller
Reprinted with permission from Dixell.
The Dixell XR-40CX (High Temperature) and XR-60CX (Medium
and Low Temperature) are fully configurable electronic
refrigeration controllers. These controls are used on PRO
3
Side
Mount units. All parameter values are reprogrammable and are
stored in the non-volatile memory.
The controller uses two levels of programming that can be
accessed through the keypad. The rst level is the user level. It
gives access to six settings — temperature dierential, defrost
cycle intervals, defrost termination temperature, draining time,
defrost fan delay and fan stop temperature.
The second level is the service level. It allows access to all other
parameters. It is recommended that changes in this level be
made only by a qualied technician.
Front Panel Commands
BUTTON COMMAND
To display target set point; in
programming mode it selects a parameter
or conrm an operation
(DEF) To start a manual defrost
(UP): To see the max. stored temperature;
in programming mode it browses
the parameter codes or increases the
displayed value
(DOWN) To see the min stored
temperature; in programming mode it
browses the parameter codes or decreases
the displayed value
To switch the instrument o, if onF = oFF
Not enabled
KEY COMBINATIONS
+
To lock & unlock the keyboard
+
To enter in programming mode
+
To return to the room temperature display
Use of LEDs
LED LED MODE FUNCTION
ON Compressor enabled
Flashing
Anti-short cycle delay
enabled
ON Defrost enabled
Flashing Drip time in progress
ON Fans enabled (XR60CX only)
Flashing
Fans delay after defrost in
progress (XR60CX only)
ON An alarm is occurring
ON Continuous cycle is running
ON Energy saving enabled
°C/°F ON Measurement unit
°C/°F Flashing Programming phase