Filter
Top Products
2-11
Henny Penny Model OE-100
2-12. FILTER HEATER
SWITCH
Checkout
The Filter Heater Switch is a rocker type switch. With the switch
in the "ON" position, the filter heater will operate, melting any
solidified shortening in the filter lines.
1. Remove electrical power supplied to unit.
Remove electrical power supplied to the fryer by unplug-
ging the unit, or turning off the wall circuit breaker, or
electrical shock could result.
2. Remove Control Panel, but leave hinged on unit.
3. Remove and label wires from the switch and check across from
top to bottom for continuity. With the switch in the "ON" position,
the circuit should be closed. If the switch is defective, replace it
by following the next step.
Replacement:
593
4. Push in on tabs on the ends of the switch and pull switch from the
front of the control panel.
5. Replace new switch, replace wires, and install controlpanel.