Filter
Top Products
--- 10 ---
Swing cutting
Orbital cutting
Orbital cutting
Orbital cutting function is not provided.
Orbital cutting function is not provided.
Orbital cutting
Orbital cutting
Orbital cutting function is not provided.
0
10
20 30 40 50
CR 13VA
CR 10V
A
B
C
D
E
F
Cutting time (sec./cut)
Straight cutting
Swing or orbital cutting
7. COMPARISONS IN CUTTING TIME
The following test data should be used for reference purposes only since the cutting time may vary depending on
the operating conditions such as the cutting function, pressing force, type of blade, etc. The graph shows the time
(in sec.) required to cut a piece of each material.
7-1. Cutting Steel Pipes
HITACHI genuine blade No. 103
for cutting steel pipes
A steel pipe less than 42 mm (1.65") in inner diameter and
3.2 mm (0.13") in thickness
Pressing force about 4 kgf (8.8 lbs.)