Filter
Top Products
– 40 –
MAINTENANCE
CLEANING
Wash, rinse, and sanitize the product probes before and after use as you would any food-contact
utensil that measures temperature.
Chiller surfaces of stainless steel should be wiped clean with a damp cloth or mild cleaning solution.
DO NOT flush with running water. Avoid the use of solvents around plastic or painted areas; clean
these with a damp cloth moistened with a solution of mild detergent and warm water. Clean hinge
hardware with a chrome cleaner. Use a solution of warm water and baking soda to clean the gasket;
then wipe with a soft cloth. Hinges may require occasional lubrication of the plastic cam. The top of
the chiller is not to be used for storage.
CONDENSER COIL
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE CLEANING ANY PARTS OF
THE UNIT.
Check the condenser coil weekly. Air must be able to freely circulate through the condenser. This
surface must be kept free of dirt and grease for proper system operation. Carefully clean dirt and lint
from the condenser coil using a vacuum cleaner, whisk broom or soft brush; do not use a wire brush.
CAUTION: Do not damage the condenser coil fins. Replace cover. Reconnect electrical power
supply.
ERROR MESSAGES
Contact your Hobart service technician if either of the following error messages appears: [
COMPRESSOR
FAILURE ], [ DEFROST NOT WORKING ].
MAINTENANCE PROGRAM
For additional information or to discuss a maintenance program, contact your local Hobart authorized
refrigeration service company.
FORM 34643 Rev. A (Sept. 2001) PRINTED IN U.S.A.