Filter
Top Products
– 9 –
Push the four control cables with connectors [ J5 ], [ J7 ], [ J9 ] and [ J12 ] down TUBE #2. Refer to the
table below and Figs. 8 and 10. Connect the four cable connectors to the control board as shown in
Fig. 11. Attach the cables to the hinge with the wire-wrap provided.
Once all wires are connected and secured in the controller section, pull up the excess length so the
wires do not hang freely in the controller section (Fig. 9).
From the top electrical box, seal
TUBE #1 and TUBE #2 (Fig. 8) around the wires so warm air and foreign
matter do not reach down the tubes into the controller section. Duct seal (putty) is supplied with the
cabinet.
TUBE #2
PL-41544-1
CONTROL CABLES
J5, J7, J9, J12
Fig. 10
SELBACLORTNOC
NOLEBAL
ELBAC
FOREBMUN
SERIW
NOLEBAL
ROTCENNOC
NOLEBAL
DRAOBLORTNOC
YTIVAC
SEBORP
85JSEBORPYTIVAC
LIOC/RIA47JLIOC
RWP3 21JRWP
DRAOBO/I019JDRAOBO/I
Fig. 11
J9
J7
J5J12
REAR OF
CONTROL
BOARD