Filter
Top Products
– 23 –
Loading V-Spits or Thermo-Wave Spits on the Rotor
1. Place pointed end of V-spit into outside hole on non-drive side of rotor (Fig. 21).
2. Fit notched end of V-spit into appropriate holes on drive side of rotor (Fig. 22).
3. Make sure the spit is level. If the spit is not level, you might be using the wrong holes.
NON-DRIVE SIDE DRIVE SIDE
Fig. 21 Fig. 22
Loading Fork Spits on the Rotor
1. Place pointed ends of fork spit into appropriate holes on the non-drive side of the rotor (Fig. 23).
2. Fit the notched end of fork spit into appropriate holes on the drive side of the rotor (Fig. 24).
NON-DRIVE SIDE DRIVE SIDE
Fig. 23 Fig. 24
Loading Chicken Racks or Baskets on the Rotor
Chicken Racks and Chicken Baskets hang on studs on the left and right sides of the rotor.
1. Hang the left end of a Rack or Basket on a stud on the left side of the rotor (Fig. 25).
2. Hang the right end of the Rack or Basket on the corresponding stud on the right side of the rotor at
the same height (Fig. 26). The accessory must be level.
NON-DRIVE SIDE DRIVE SIDE
Fig. 25 Fig. 26