Hobart ML-138211 Dishwasher User Manual


 
– 10 –
Mounttheprotectivemylarcovertotheplenumontopoftheblowerangeusing
blower hardware provided.
PROTECTIVE COVER
BLOWER HARDWARE
Fig. 10
Blower Motor Connections
Carefully route the blower motor cable through the p-clip, located at the center front
of the component baseplate, to the electronic overload relay. Connect the three-
phase wiring and ground pigtail leads from the overload relay to the blower motor
cable connections using the wire connectors. Refer to the blower motor connection
chart located on the blower motor for additional information (208/480 VAC only).
Make certain the blower motor cable and connections are securely routed
away from the motor fan blades to avoid damage to the connections.
ELECTRICAL CONNECTIONS
Beforemakingelectricalconnections,checkthemachinespecicationstoensure
that they agree with those of your electrical service.
Electrical and grounding connections must comply with the
applicable portions of the National Electrical Code, NFPA 70 (latest edition)
and / or other local electrical codes.
Disconnect the electrical power to the dishwasher and follow
lockout / tagout procedures. There may be multiple circuits. Be sure all
circuits are disconnected.
Control Connections
Carefully route the control cable to the control box on top of the dishwasher. Insert
the cable into the back of the control box through the strain relief (provided) and
collect extra cable inside control box. Use wire ties (provided) to secure cable
between the blower-dryer and dishwasher control box.
Make certain the control cable is securely routed along the top of the
dishwasher unit to avoid damage.
Connect the three control cable leads to the same-named terminal block connections
as shown in Fig. 11. Refer to the electrical diagram located inside the control box
cover for additional information.