– 6 –
CLe-Series
Fig. 3
MOUNT BLOWER-DRYER TO DISHWASHER
NOTE: Thedishwashermustbeinitsnalposition,adjustedforproperheightand
properly leveled before blower-dryer can be mounted.
To mount the blower-dryer, apply the 1
1
⁄2" foam sealant tape (supplied) along the
edges of the dishwasher to prevent leakage (CLe models, see Fig. 3. CLeR models,
see Fig. 3A). Also apply the 5” foam sealant tape (supplied) below the tank lip on
the dishwasher (Fig. 3 and 3A). On CLeR models, insert two ¼-20 bolts into the
weld nuts on the end of the blower dryer chamber (Fig. 3A). These will be used
as locating studs. Position the blower-dryer against the dishwasher and assemble
using the ¼-20 bolts and nuts provided (Fig. 3 & 3A). Do not tighten at this time.
CLeR-Series
Fig. 3A
1/4-20 x (12)