Filter
Top Products
– 9 –
Fig. 7
Fig. 8
MOUNT BLOWER MOTOR
Take care when installing the blower motor to avoid damaging wiring
and electrical components.
Remove front and rear panels as necessary. The top and side panel unit can be
loosened on the exit side to ease installation. However, do not remove the top and
side panel unit. Take care to avoid damaging the wiring and electrical components
mounted on the side panel.
Apply 1" foam sealant tape (supplied) along the edges of the blower motor to
prevent leakage. Carefully position the blower motor over the opening in the blower-
dryer chamber top and bolt in place using 1/4-20 hardware provided.
Fig. 9
3-PHASE MOTOR
CONNECTIONS
GROUND
CONNECTION
LEVER TYPE WIRE
CONNECTORS
ELECTRONIC
OVERLOAD RELAY