Filter
Top Products
Installing The Cabinet Doors
For NG Gas grills:
1. Install the Door Stops to the Bottom Shelf
and the Door Bracket. See Fig. 5a.
2. Align the holes on the Door Stops with the
threaded holes on the top of the Bottom Shelf
and bottom side of Door Bracket. Tighten
securely by using 4 of the 1/4"xl/2" Pattern
Head Screws provided. See Fig.5a.
3. Remove the white protective film from the
stainless steel Doors. Attach a Door Handle to
each Front Door by using 2 of the M4x5mm
Pattern Head Screws provided. See Fig. 5b.
Be careful not to scratch the Door surfaces.
4. When installing the Front Doors, make sure
the door bolt holes are located on the hinge
sides of the Cart Legs.
5. Install either Front Door by inserting 1/4"x5/8"
part-threaded bolt through the lower door bolt
hole of the Front Door and into the tapped
hote of the Bottom Shelf. Next, align the
upper door bolt hole of Front Door with the
tapped hole in the bottom of Door Bracket.
Insert 1/4"xl/2" partly-threaded bolt provided.
Tighten both bolts securely.
6. Repeat these steps to install the other Front Door.
7. Install the Cart Spice Basket to the inside of Left
Door. Align the threaded holes on the inside of Left
Door with the holes on the Cart Spice Basket.
Tighten securely by using 2 of the 1/4"xl/2" Pattern
Head Screws provided. See Fig.5b.
8. Install the Cart Spice Basket to the inside of Right
Door. Align the threaded holes on the inside of Right
Door with the holes on the Cart Spice Basket.
Tighten securely by using 2 of the 1/4"xl/2" Pattern
Head Screws provided. See Fig.5b.
Figure 5a (NG gas model only)
BRACKET
Foundin
Hardware Pack
SHELF
Figure 5b (NG gas model only)
DOOR
BRACKET
UPPER DOOR
BOLT HOLE
FRONT DOOR
,LEFT
DOOR_
HANDLE
CART SPICE
BASKET SHELF
• When you have finished assembling your
grill we strongly urge that all Pattern
Head Thumb Screws be tightened, either
with the supplied Tightening Tool or a
#2 Phillips Head Screwdriver.
Tightening Tool
Ref. # P05515102K
CART SPtCE
BASKET
FRONT DOOR
,RIGHT
15