Filter
Top Products
CAUTION:Spidersand smallinsectsocca-
sionallyspin websor make nestsin the grill
BurnerTubesduringtransitandwarehousing.
Thesewebscan leadto a gas flowobstruc-
tion whichcouldresultin a fire in and
aroundthe BurnerTubes.This typeof fire is
knownas a "FLASHBACK"andcan cause
seriousdamageto yourgdll and createan
unsafeoperatingconditionfor the user.
To reducethe chanceof "FLASHBACK",you
mustcleanthe burnertubesbeforeassem-
blingyourgrill, and at leastoncea monthin
latesummeror earlyfall whenspidersare
mostactive.Alsoperformthis BurnerTube
cleaningprocedureif yourgdll has not been
usedfor an extendedperiodof time.
To reducethe chanceof "FLASHBACK"(see
CAUTIONat right)cleanthe BurnerTubesand
Burnersbeforefully assemblingyourgdll. Re-
movethe CotterPinfrom the rearundersideof
eachBurnerusinga pair of long nosepliers.
Carefullylift eachBurnerup and awayfrom the
GasValveOrifice,then referto Figure 1 and
performone of thesethreecleaningmethods:
.
Bend a stiff wire, (a lightweight coat hanger
works well) into a small hook as shown
below. Run the hook through the Burner
Tube and inside the Burner several times to
remove any debds.
{ ')
. Use a bottle brush with a flexible handle.
Run the brush through the Burner Tube and
inside the Burner several times, removing any
debds.
.
Use an air hose to force air through each
Burner Tube. The forced air should pass
debris or obstructions through the Burner and
out the Ports.
Figure 1 SPARK ELECTRODE AS- GAS COLLECTOR BOX
INSERT HOOK HERE
HEAT-INSULATING RING BURNER TUBE COTTER PIN
• Long nose pliers can be used to remove
Cotter Pin when cleaning the Burners
• Use work gloves to protect your hands
• Wear eye protection
• When you have finished assembling your
grill we strongly urge that all Pattern
Head Thumb Screws be tightened, either
with the supplied Tightening Tool or a
#2 Phillips Head Screwdriver.
Tightening Tool
Ref. # P05515102K
/ kWARNING
The location of the Burner Tube with
respect to the Orifice is vital for safe
operation. Check to ensure the Orifice is
inside the Burner Tube before using your
gas gdll. See Fig. 2. If the Burner Tube
does not fit over the Valve Odfice, lighting
the Burner may cause explosion and/or fire.
Figure 2
GAS VALVE ASSEMBLY
r-
5
ORIFICE BURNER TUBE