Filter
Top Products
Ignitor Battery Installation - See Fig. 9
1. Unscrew both Ignitor Caps located on the grill
Control Panel and remove the Contact and
Spring from each Ignitor Slot.
2. Place the manufacturer supplied AA battery
into each Ignitor Slot. Be sure to place the
_ po_ &c_g _L_:]. _OL_.S_ Fig. 9
3. Place the Spring over the AA battery, then
place the Contact on top of the Spring.
Screw the Ignitor Cap back onto the grill
Control Panel.
4. Remove any protective film from outside and
inside of Grill Head.
IMPORTANT: Before use of this grill please
refer to Cleaning Exterior Stainless Steel
Surfaces found on page 27 of this Owner's
Manual.
Figure 9
IGNITOR SLOT
IGNITOR CAP,
SPRING
CONTACT
Electrode Check - Requires an Assistant
Before placing the cooking components into your
grill, ensure that the Spark Electrode Tip is properly
positioned within each Gas Collector Box ( a
3-1/4" wide stainless mechanism found at the front
between each set of Burners.) The easiest way to
ensure this is to perform this Electrode Check:
1. Be sure all Control Knobs are set to "OFF"
and open the Grill Lid.
2. Have an assistant stand behind to the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside Grill Head.
3.
Press the Ignitor Cap. You should hear a
"clicking" sound and your assistant should see
a small blue spark within each Gas Collector
Box. If a spark is present the Electrode Tips
are properly positioned.
4. If no spark is seen the Spark Gap shown in
Fig. 10 needs to be adjusted as follows:
Using an adjustable wrench, loosen the Inside
Nut just until the Gas Collector Box can be
maneuvered and turned upward.
The gap between the Spark Electrode Tip and
Spark receiver should be approximately 3/16".
If the gap is wider than 3/16" use a pair of long
nose pliers and gently squeeze the Gas Collector
Box until the gap is correct.
Return the Gas Collector Box to its original
horizontal position, secure the Inside Nut and try
the Electrode Check again.
5.
If no "clicking" sound is heard check the following
common causes. If you need assistance call our
Customer Service Helpline
at 1-888-317-7642.
• Ignitor AA battery not installed properly.
Ignitor wires may be loose. Remove the AA
battery, inspectthe Ignitor Junction Box found
behind the Control Panel, and connect any loose
wires.
Figure 10 - Side View Figure
GAS COLLECTOR BOX
19