Filter
Top Products
7. Immediately press the left Electric Ignitor for
3-4 seconds to light the Burner.
Basic Lighting Procedures
Machine oils used in the manufacturing process of
stainless steel can cause stainless steel to tum a tan
color. Before initial grill use, remove protective PVC film
from Control Panel and inside and outside of Grill Lid.
Use a Stainless Steel Cleaner to polish the stainless steel
and remove these excess oils from your grill. Never use
abrasive cleaners or scrubbers because they will scratch
and damage your grill. For details, see Cleaning Exterior
Stainless Steel Surfaces on page 27.
Gas Lighting Instructions
Familiarize yourself with the safety guidelines at the
front of this manual. Do not smoke while lighting grill
or checking gas supply connections.
1. If you have a LP gas grill be sure the LP gas tank
is filled, or if you have a NG grill be sure that the
locking shut off valve is open.
2. Check that the end of each Burner Tube is
properly located over each Valve Orifice.
3. Be sure all gas connections are securely tightened.
4. Open the Grill Lid or Side Burner Lid, depending
on the Burner you are lighting.
Z WARNING
Failure to open Grill Lid during the
lighting procedures could result in a fire
or explosion that could cause serious
bodily injury, death, or property damage.
5. Set ALL Control Knobs to OFF and open the LP
gas tank valve slowly until 1/4 to 1/2 open.
Open LP
gas tank
OFF
\
6. Push and turn the any Control Knob for Main
Burner to HIGH.
HIGH
"-_. PRESS LEFTELECTRIC
IGNITOR
.
g.
If the burner does not light, turn the Control Knob
to OFF, wait 5 minutes for gas to clear, then
retry.
Once the grill burner is ignited, the adjacent
burner can be lit by simply turning its Control
Knob to HIGH.
10. Adjust Control Knobs to your desired cooking
temperature.
Side Burner Lighting Instructions
1. Follow steps 1 through 5 of the Basic Lighting
Procedures.
2. Push and turn the control knob (on the right side
burner frame ) for Side Burner to HIGH.
HIGH
RIGHT ELECTRIC
OFF iGNITOR
(for SIDE BURNER)
\
© ,
©©
.
4.
5.
Immediately press the right electric ignitor for 3-4
seconds to light the burner.
If the burner does not light, turn the control knob to
OFF, wait 5 minutes for gas to clear, then retry.
Adjust control knobs to your desired cooking
temperature.
LEFT ELECTRIC
OFF _GNITOR
°_ _, ,©,
MAIN BURNER 24