Filter
Top Products
22
W Set the fastening screws 9 on the opposite side, and
screw in briefly.
W Screw out the door fastening screws bl and place the
hinges diagonally.
Caution Do not allow the hinges to fold inwards -
an injury could be caused!
- Use a cordless screwdriver - to fasten the screws. The
screws bl are self-piercing.
W Use the plugs to seal bm the former fastening holes.
W Fit the doors of the appliance onto the prefitted screws 9
and fasten the screws.
Refit the closing damper
2
* :
W
Screw
1
the holder back on
W
Screw the ball pins
3
together with the closing damper
2
into the new fastener holes.
W Refit all the cover components .
You will also need the following tool for the installation: cordless
Torx screwdriver
®
15, 20, 25, hexagon spanner 13.
Replacing the door stop
If necessary you can change the door stop, please see further
instructions from “installation information” onwards
W To make it easy to fit, push the appliance three-quarters
of the way into the niche. Open the door.
W
Dismantle the closing damper :
Caution when dismantled the closing damper retracts!
W
Unscrew the holder
1
W
Unscrew the ball pins
3
, together with the closing damper
2
, from the door, and place to one side.
Caution: Do not pull the closing damper from the ball
pins. It could become damaged
W Pull the cover components 5, 6, 7 and 8 forwards and
upwards with the aid of a slotted screwdriver.
W Simply loosen the fastening screws 9 on the body of the
appliance at the top and bottom .
- Push the doors outwards and take them off their hinges.
5
6
7
8
9
11
10
10
7
9
9