Filter
Top Products
25
GB
W Align the depth of the unit door Z :
- top: loosen screws dr�
- at the bottom: loosen the hexagonal
screws dq with the ring spanner sup-
plied ds and adjust the door.
- Allow an air gap of approximately 2 mm
between the unit door and the body of
the unit. Do not allow any burls or seal-
ing lips to touch - this is important for
correct function!
W For large unit doors, fit a third pair of fas-
tener brackets dp.
To do this use the predrilled holes in the
handle area of the appliance door.
W Check that the doors are correctly seated and adjust if nec-
essary. Tighten all screws.
- Tighten the lock nuts dn with the ring spanner ds hold the
adjusting bolts do with a screwdriver as you do so.
W If necessary, adjust the shim cl by pushing it parallel to the
floor of the unit. It must not protrude.
W Fix the appliance underneath with the plastic bracket cs us-
ing a second screw cu to fasten it into the round hole.
W Fit all the covers:
- Position the upper covers dt and en-
gage them.
- Position the side covers du as far as
the stop, then press the cover until it
engages with an audible click.
- Push the cover el at the side, using a
screw driver, to pull the cover forward so
that it engages correctly.
W You can now adjust the end
stop spring on the doors. Make
the setting as required with the
allen key 5 supplied:
- turn clockwise
= stronger spring force,
- turn counter-clockwise
= weaker spring force (condi-
tion in which supplied).
W Place the rest of the covers on
the hinges
_______________________________________________
The manufacturer is constantly developing and enhancing all
types and models. Please therefore understand that we reserve
the right to make changes to the shape, options and technology
used.
20
37
32
29
27
40
39
38
38
39
40
Z
Z
31
34
36
33
37
35
=
=
=
ca. 2mm