Filter
Top Products
5
To start the ice maker
The ice maker will only work if the combined refrigerator-freezer
is connected to the electricity supply. It will only make ice cubes
if the freezer compartment is operating.
The ice maker is in the top left drawer in the freezer compartment
of the combined refrigerator-freezer. You can identify this drawer
by its labelling ”Ice maker”.
To switch on
• Pull out the drawer.
• Press the ”ON/OFF”
button so that the control
lamp comes on.
• Close the drawer.
Note: The ice maker can
only make ice cubes if
the drawer is completely
closed.
To switch off
If you do not need any ice cubes the ice maker can be switched
off independently of the freezer compartment.
• Press the
”ON/OFF” button for approx. 1 second so that the
control lamp goes out.
Note: If the ice maker is switched off, the empty drawer can
also be used to freeze and store food.
To make ice cubes
After you start the ice maker for the first time it may take up to 24
hours before the first ice cubes are ready.
Please note that the first three batches of ice must not be
consumed or used.
The production capacity depends on the temperature inside the
freezer compartment. The lower the temperature, the more ice
can be produced over a period of time.
The ice cubes fall out of the ice maker into the drawer. When
the ice reaches a certain level in the drawer, the appliance stops
producing ice automatically.
If you require a large quantity of ice you can swap the drawer to
the right with the complete ”Ice maker” drawer. When you close
the drawer the ice maker will immediately start production.
Cleaning the ice-cube tray
The ice-cube tray can be cleaned. Use the following method.
• The IceMaker must be switched on.
• Remove any ice cubes from the drawer.
• Hold the ”ON/OFF” button for 10 seconds (after 1 second the
IceMaker will switch off - the LED will go out).
• After you have held the ”ON/OFF” button for 10 seconds the
LED will start to flash for 60
seconds.
• Insert the drawer during
these 60 seconds. Then
the ice-cube tray will move
into an angled position.
• Remove the drawer - the
ice-cube tray can now be
cleaned. The best way of doing
this is with warm water and a little
washing-up liquid.
• Press the ”ON/OFF” button and close the drawer. The IceMaker
will then immediately restart with its production of ice cubes.
This procedure should also be completed if you switch off the
IceMaker. This ensures that no water or ice will be left in the ice-
cube tray.
Malfunction
If a malfunction occurs during operation, check whether it is due
to an operating error.
You may be able to rectify the following faults yourself:
• The ice maker cannot be switched on
- Is the combined refrigerator-freezer connected to the mains
electricity supply?
• The ice maker is not making any ice
- Is the ice maker switched on?
- Is the water supply line open?
- Is the
”Ice maker” drawer closed properly?
If you are unable to rectify the fault yourself or if the control lamp
above the ”ON/OFF” button flashes, contact our customer service
department. Refer to the section headed ”Troubleshooting” in the
operating instructions for the combined refrigerator-freezer for
details of the type plate data you will be required to quote.
GB