Filter
Top Products
15
Ice Dispenser Operation
To dispense ice:
• Select Cubed or Crushed ice mode by pushing button on dispenser control panel. A green
indicator light above button shows mode selection.
• Press container against dispenser pad. When dispensing crushed ice, hold container as close
to chute as possible to reduce spraying. Selection mode may not be changed while ice dispenser
is in operation.
NOTE: If dispenser is active for more than 3 minutes, an automatic lock out sensor will shut down power
to dispenser area. See Automatic Lock Out for further information.
Dispenser Features
Control Features
(Five button control)
Dispenser Lock
This feature prevents ice or water from being dispensed.
To lock and unlock dispenser:
• To lock dispenser, press and hold Dispenser Lock button for
3 seconds. A green indicator light above button confirms
dispenser is locked.
• To unlock dispenser, hold Dispenser Lock button for 3 seconds.
Green indicator light above button will go out.
What is the Automatic Lock Out feature?
The Automatic Lock Out feature shuts down power to the
water and ice dispenser when either dispenser has run
continuously for approximately 3 minutes. If this mode goes
into effect, the green light will activate above the Dispenser
Lock button.
To unlock dispenser:
• To unlock dispenser, hold Dispenser Lock button for 3
seconds. Green indicator light above button will go out.
Filter Status Indicator Light
The Filter Status Indicator Light serves as a reminder to replace the water filter. A green light indicates that the
filter is in good condition. A red light indicates the filter should be changed. Once light turns red, it will remain
red until function is reset.
To reset indicator:
• Press and hold both Dispenser Lock and Water buttons simultaneously for 4 seconds. The green Filter Status
Indicator Light will flash 3 times when the function has successfully reset.
Auto Light
The Auto Light function offers the ability to activate the dispenser light at half-power when the Light Sensor
detects that the light levels in room are low.
To activate and deactivate Auto Light:
• To activate, press Auto Light button located on control panel. A green
indicator light above button displays to show that sensor is active.
• To deactivate, press Auto Light button. Green indicator light will go out.
NOTE: Dispenser light will operate whether
or not Auto Light is selected.
Sabbath Mode (some models)
This mode is intended to deactivate power to the LED and dispenser lights,
while allowing the controls to remain operational.
To activate Sabbath Mode:
• Press and hold both Dispenser Lock and Auto Light buttons simultaneously
for 3 to 4 seconds. After 3 to 4 seconds, the LED and dispenser lights will turn
off. Dispenser light will not activate during dispensing while in this mode.
To deactivate Sabbath Mode:
• Press and hold both Dispenser Lock and Auto Light buttons simultaneously for 3 to 4 seconds. After 3 to 4 seconds,
the LED and dispenser lights will activate.
NOTE: In the event that power is
interrupted while the Sabbath Mode
is active, the control will remain in
Sabbath Mode when power returns.
+