Maytag 12591308 Refrigerator User Manual


 
16
Dispenser Features
Control Features
(Electronic control)
What is the Automatic Lock Out feature?
The Automatic Lock Out feature shuts down power to the water and ice dispenser when either dispenser has run continuously for approximately
2 minutes. If this mode goes into effect, the green light will activate above the
button.
To unlock dispenser:
To unlock dispenser, hold
button for 3 seconds. Green indicator light above button will go out.
Dispenser Lock
This feature prevents ice or water from being dispensed.
To lock and unlock dispenser:
To lock dispenser, press and hold the button for 3 seconds. A green indicator light above button confirms dispenser
is locked.
To unlock dispenser, hold the button for 3 seconds. Green indicator light above button will go out.
To dispense ice:
Press the
button for crescent ice.
Press the
button for crushed ice.
Water and Ice Dispensing (main activator)
The water and ice dispensing functions work independently of each other.
To dispense water:
Press the
button
Press water activator
Filter Status Indicator Light
The Filter Status Indicator Light serves as a reminder to replace the water filter. A green light indicates that the
filter is in good condition. A red light indicates the filter should be changed. Once light turns red, it will remain red
until function is reset.
To reset indicator:
Press and hold both the
and the buttons simultaneously for 4 seconds. The green Filter Status Indicator Light
will flash 3 times when the function has successfully reset.
Light Function
The Light function offers offers two setting: OFF and AUTO.
The OFF setting allows the light to function only as a dispenser cavity light.
The AUTO setting allows the SENSOR to measure the surrounding light levels and adjust the power of
the cavity light accordingly. When the sensor registers lower light levels (night time, darkened kitchen), the cavity light will
respond at 50% power. When the sensor registers high light levels (lighted kitchen, direct sunlight), the cavity light will not
activate.
To deactivate the AUTO setting:
Press the
button located on control panel. When the green indicator light above button display is off, the light will
function only when dispensing ice or water.
To activate the AUTO setting, press the
button. When the green indicator light above the button display is on, the
cavity dispenser light will use the AUTO setting.
NOTE: Dispenser light will operate at full
power when ice or water functions are in use.