Filter
Top Products
5
Installing Your Refrigerator
Remove two
1
/
4
" hex nut
screws from bottom of
refrigerator
and freezer door.
How to Install and Remove Handles
1
Insert screws removed in step 1
into screw holes at bottom of
handle section.
2
Align door handles with top
and bottom sets of door clips,
and slide down until screw
holes on bottom of handles
match with door screw holes.
Snap trim over bottom portion
of handles and retainers on
bottom of door
3
Full-Length Grab Handles (non-stainless steel)
4
To remove after initial install...
• Follow steps 3 through 4 in reverse order.
NOTE: Fit may be tight. When removing handle, pull up and
out.
Half-Length Grab Handles (non-stainless steel)
Remove four
1
/
4
" hex nut
screws from top and
bottom of doors.
1
2
Align door handles with
screw holes and insert screws
removed in step 1.
Snap colored handle trim over
screw holes at top and bottom of
handles.
• Snap in trim by inserting large round
end first.
3
To remove after initial install...
Handles may need to be removed if transporting unit
through tight spaces.
• Follow steps 2 and 3 in reverse order.
IMPORTANT: To avoid damage to handle, use a
flat blade screwdriver edge wrapped in masking
tape to remove colored handle trim.
Handles are located within fresh food section of refrigerator. Trim, plugs, and accent pieces will be located within the
literature assembly.
Fit other end of handle over
upper door clip and slide
up as far as possible.
3
Stainless Steel Models
Loosen lower door clip on
refrigerator door with
1
/
4
"
hex nut driver.
1
Insert
1
/
4
" hex nut
driver into predrilled hole at
base of handle and tighten
screw.
4
Locate predrilled hole at
base of handle, and fit
hollow end of handle over
lower door clip.
2