Filter
Top Products
Oven interior
The side runners, oven interior, back
panel and roof liner are coated with
pyrolytic enamel which facilitates
cleaning.
This is a particularly hard enamel with
an extremely smooth surface.
Because of its anti-stick properties
most debris can be easily removed with
warm water and a little washing-up
liquid applied with a soft cloth. This
should be done after each use.
Allow the oven to cool down before
cleaning.
Danger of burning!
Never use hard brushes, hard
sponges, wire wool pads*, knives or
any other abrasive materials or
cleaning agents. They can damage
the enamel.
If using an oven spray, the
manufacturer's instructions must be
followed.
* non-abrasive stainless steel spiral
pads can be used
Pyrolytic cleaning of the oven
interior
Before starting a pyrolytic cleaning
process please note the following
advice:
Remove any coarse soiling from the
oven before you start.
Clean the interior glass door panel
thoroughly. Otherwise, splashes on
the door may burn on making them
difficult to remove.
There is a fibre-glass door seal
around the oven cavity.
This seal is particularly sensitive and
should not be cleaned unless
absolutely necessary. Rubbing the
seal can damage it.
Remove all accessories (except the
side runners) and any extra
accessories from the oven interior
before starting the pyrolytic cleaning
process. The high temperatures
needed for pyrolysis will damage the
accessories and cause irreparable
damage.
The oven door gets much hotter
during pyrolytic operation than
during normal use.
Make sure children cannot touch the
oven whilst a pyrolytic programme is
running. Danger of burning.
Cleaning and care
51