Filter
Top Products
Stop and Go
Your appliance has a Stop and Go
feature which, when activated, reduces
the power of all switched-on cooking
zones to setting 1. When Stop and Go is
deactivated, the cooking zones resume
at the power level which was last set.
If Stop and Go is not deactivated, the
hob switches off after 1 hour.
If you wish to use this feature, you will
need to alter the factory setting (see
"Programming").
When Stop and Go is activated
- the countdown of a time
programmed in for Automatic
switch-off will be interrupted. When
deactivated, the time will continue
to run.
- the minute minder will continue
without interruption.
- the recording of a Memory
programme will be cancelled.
To activate Stop and Go
^
Touch the $ sensor until you hear
two consecutive beeps.
Be careful not to continue touching
the $ sensor for too long, as this will
activate the safety lock.
The indicator lamp for the safety lock
will start to flash. The power of the
cooking zones in use will be reduced to
setting 1, and a 1 will appear in the
corresponding cooking zone displays.
To deactivate Stop and Go
^ Touch the $ sensor until the indicator
lamp goes out.
The cooking zones will now run at the
level that was previously set.
Safety features
34