Filter
Top Products
... one of the following has occurred:
–
The Booster has deactivated early
automatically.
–
The set power level 10, 11 or 12 is
alternating in the display with a lower
power level. The reduced power
level is also indicated by the number
of lines in the light-ring.
The overheating protection mechanism
has been triggered (see "Overheating
protection").
... the food in the pan hardly heats up
or does not heat up at all when the
Auto heat-up function is switched on
This could be because:
– there is too much food in the pan.
– the pan not conducting heat
properly.
Select a higher continued cooking
setting next time, or start cooking at the
highest setting and then turn down to a
lower setting manually later on.
... The cooling fan continues to run
after the appliance has been
switched off.
This is not a fault. The fan will continue
running until the appliance has cooled
down. It will then switch itself off
automatically.
... numbers light up in the Timer
display, and A, F and numbers light
up in the cooking zone display, when
the hob is switched off.
The sensitivity level of the sensors has
altered and they are unable to
recalibrate automatically. The sensors
must be recalibrated manually (see
"Calibrating the sensor switches").
If this does not solve the problem,
please call the Miele Service
department.
... an F appears in the display for the
left hand cooking zones, an E
appears in the display for the right
hand cooking zones and numbers
appear in the timer display.
Interrupt the power supply to the hob
for approx. 1 minute.
If the problem persists after
reconnecting the appliance to the
power supply, please contact the Miele
Service department.
Problem solving guide
43