Filter
Top Products
. . . "Fault -75" appears in the display.
The sensors in the waste container
compartment are dirty.
^
Pull out the waste container and
clean the interior of the compartment,
paying particular attention to the
sensors (small window shapes) at the
top right and left hand side.
^
Replace the waste container in the
machine.
The coffee capsule was not pushed
onto the capsule plate.
^ Pull the carousel runners out of the
machine.
^ Clean the area under the carousel
runners. It is particularly important to
clean the sensor which is used to
recognise the capsule chambers as
well as the recess in the floor. Wipe
everything dry using a soft cloth.
^
Replace everything in the machine.
The coffee capsule is lying on the
capsule plate.
^
Open the front of the machine.
Press the master switch in the
machine at the top left to
disconnect it from the mains.
^
Pull the carousel runners out of the
machine.
^ There is an opening to the right of the
slot for the capsule plate. Check
whether a coffee capsule is lying on
top of the capsule plate.
^ Push the coffee capsule with your
finger back into the waste container.
^
Switch the machine on again with the
master switch.
^
Close the machine front and follow the
instructions given in the display.
Problem solving guide
61